radius-server-policy

Creates a RADIUS server policy and enters its configuration mode

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

radius-server-policy <RADIUS-SERVER-POLICY-NAME>

Parameters

radius-server-policy <RADIUS-SERVER-POLICY-NAME>


<RADIUS-SERVER-POLICY-NAME>	Specify the RADIUS server policy name. If a policy with the specified name does not exist, it is created.

Examples

nx9500-6C8809(config)#radius-server-policy testRadiusServerPolicy
nx9500-6C8809(config-radius-server-policy-testRadiusServerPolicy)#?
Radius Configuration commands:
  authentication           Radius authentication
  bypass                   Bypass Certificate Revocation List( CRL ) check
  chase-referral           Enable chasing referrals from LDAP server
  crl-check                Enable Certificate Revocation List( CRL ) check
  ldap-agent               LDAP Agent configuration parameters
  ldap-group-verification  Enable LDAP Group Verification setting
  ldap-server              LDAP server parameters
  local                    RADIUS local realm
  nas                      RADIUS client
  no                       Negate a command or set its defaults
  proxy                    RADIUS proxy server
  session-resumption       Enable session resumption/fast reauthentication by
                           using cached attributes
  termination              Enable Eap termination for proxy requests
  use                      Set setting to use

  clrscr                   Clears the display screen
  commit                   Commit all changes made in this session
  do                       Run commands from Exec mode
  end                      End current mode and change to EXEC mode
  exit                     End current mode and down to previous mode
  help                     Description of the interactive help system
  revert                   Revert changes
  service                  Service Commands
  show                     Show running system information
  write                    Write running configuration to memory or terminal

nx9500-6C8809(config-radius-server-policy-testRadiusServerPolicy)#

Related Commands


no	Removes an existing RADIUS server policy

Note

For more information on RADIUS server policy commands, see RADIUS Policy.